19
I stopped using Bondo on every dent after a mentor showed me a stud welder in 2019
Used to think filler was the only way to fix a panel, but pulling with a slide hammer leaves way less work to sand down. Anybody else dump the filler for a welder on smaller dings?
2 comments
Log in to join the discussion
Log In2 Comments
alexlewis3d ago
Ditched filler years ago after a buddy showed me his stud welder and I haven't looked back since. Pulling dents out is so much cleaner and you don't end up with a mountain of sanding dust everywhere lol
4
matthewperry3d ago
@alexlewis is spot on with that. Once you go stud welder you NEVER go back. Filler is for lazy hacks or people who don't know better. Sanding dust gets every damn where and you lose the factory shape. Pulling the dent out keeps the panel crisp.
1