Tried a $9 non-contact voltage tester on a dead outlet and got a reading that made no sense
I picked up one of those cheap pen-style voltage testers at the hardware store in Fresno to chase down a dead outlet in my garage, and it lit up on a wire I was sure was off at the breaker. Turned out the wire was picking up voltage from a parallel run bundled tight in the same conduit, which is called a phantom voltage, and my tester was too dumb to tell it apart from real power. I grabbed my multimeter and read 11 volts where the tester said full hot, which is basically nothing but enough to spook a tester. The lesson is that those pens are great for a quick yes or no on a live circuit but they lie about what is truly dead. I now always confirm with a meter before I touch anything, and I flip the breaker back on to prove the meter works, then off again to prove the circuit is dead. Anyone else get fooled by a phantom reading and swap out a switch that was never the problem?
A buddy of mine went through the same thing last fall, chasing a dead outlet in his kitchen. He had one of those pens and it buzzed on a wire he was sure was off, so he swapped the switch, then the outlet, then started in on the breaker. His wife finally made him call an electrician, who put a meter on it and read about 14 volts, phantom voltage from a wire running alongside it in the wall. Two days and about 40 bucks in parts for nothing. He keeps the pen in his glovebox now and uses a meter for anything he is about to put his hands on.