Loading…
10
My dovetail jig setup was backwards for 4 months and the plywood scraps finally told me
Kept getting chipped tear-out on the left pin board of every drawer I cut in my shop near Dayton, and it turned out the fence offset was set to 3/8 when my bit needed 1/4, so I was basically shaving the grain the wrong way on 60 plus drawers before a scrap pile caught my eye, anyone else figure out a jig mistake from the trash bin?
0 comments
Log in to join the discussion
Log In0 Comments
No comments yet
Be the first to share your thoughts on this discussion.